Tiny magnetic discs offer remote brain stimulation without transgenes

2024-10-14

MIT-BrainStimulation-01-press_0(1).jpg

@news.mit.edu

Novel magnetic nanodiscs could provide a much less invasive way of stimulating parts of the brain, paving the way for stimulation therapies without implants or genetic modification, MIT researchers report.

The scientists envision that the tiny discs, which are about 250 nanometers across (about 1/500 the width of a human hair), would be injected directly into the desired location in the brain. From there, they could be activated at any time simply by applying a magnetic field outside the body. The new particles could quickly find applications in biomedical research, and eventually, after sufficient testing, might be applied to clinical uses.

Source from: https://news.mit.edu/2024/tiny-magnetic-discs-offer-remote-brain-stimulation-without-transgenes-1011

In the paper, the MATLAB-Simulink model of simulation of operation of the fast light innovative regional train from “Serbian Railways” in traction and braking mode is exposed where changes are observed: stator currents of three-phase traction motors, traction electric motor speeds and electric multiple units, electromagnetic torque on the rotor shaft of the traction electric motor, and direct current bus voltage. The model allowed review of the listed parameters for: different allowed values of contact network voltage and total voltage distortion at the place of connection of the electric multiple unit to the contact network; different mechanical loads of the electric multiple unit and traction electric motor; and different train speeds and rotations of traction electric motors. Appropriate conclusions were made through the analysis of the simulation results obtained.

This paper defines vehicles and buildings as main sources of United Kingdom (UK) carbon dioxide (CO₂) and seeks to cut such emissions using green hydrogen made from combined wind and solar energy. Combustion vehicles powered by fossil petroleum emit near half of UK climate-warming CO₂ while buildings heated by natural gas provide a third. First, current UK grid problems are defined: Electricity, gas and petroleum grids. Refueling green vehicles has been a particular problem. Then experiments on the private wire community of Keele University show how green hydrogen could integrate both green vehicles and buildings. Next, the model supply chain is planned and tested. Finally, experiments and calculations are outlined, analyzing the optimum system design criteria proposed. We conclude that economic green hydrogen can displace petroleum in vehicles, while powering buildings instead of natural gas. Also, the prospect in 2024 is that profits can be made all along the green hydrogen supply chain, such that new businesses involved in local private clean communities can cost less than the National Grid monopoly and other dominant fossil energy companies.

Presently, dynamic impacts occurrences caused by car crashes have been frequently reported. Statistical results from different articles indicate that vehicle crashworthiness of bridge pier supersedes the other events. However, majority of the published articles focusses on sustainability and finding severity of distressed pier due to impact correlating faster construction methods, like accelerated bridge construction (ABC). This article is an attempt to examine post impacted behavior of a commonly used connector in ABC for resisting short duration shock. Static and dynamic performance analyses of a connector embedded within a coupler system has been examined. A representative ABC pier with the standardized and selected material properties collected from manufacturer’s data has been utilized. Coupler composite materials consisting of a hollow uniform cross-section cast iron cylinder filled up with specified concrete grout conforms higher strength. The performance examination has been conducted by numerical modeling using finite element method (FEM). A commercially used software ANSYS has been utilized for carrying out the simulations. To investigate the post impact dynamic behavior, mesh-independent studies seems inevitable and hence are executed to evaluate dynamic impact factor (DIF). Sensitivity studies are carried out for validating results in precision. The DIF of the main reinforcing tensile steel embedded into the grout placed inside the connector has been determined. Results captured from simulations to identify material properties at plastic stage in sustaining such load have been conducted. The results provide significant information that aids opting for selecting suitable connectors for attaining help the design offices.